How to Fix Hot Fast Grinding Machine

how+to+fix+hot+fast+grinding+machine
How to Fix Hot Fast Grinding Machine
How to Fix Hot Fast Grinding Machine - One of the problems that often occurs in the hand grinding machine is the hot fast machine. Although the heat will disappear when turning off the grinding machine a while, but if the problem is not immediately repaired, the damage will become worse.

The cause of the hot fast hand grinding machine is the presence of friction between the grinding machines. The friction is usually due to the position of the unbalanced part. When spinning, the unbalanced part will dissuckle the other part, so it will produce friction and heat that propagate over the parts of the hand grinding machine.

To make improvements to the fast hot grinding machine, we have to do the grinding machine to know the cause. And the following are the causes and how to repair hot fast hand grinding machine.

Causes and How to Fix Hot Fast Grinding Machine


1. Drag Bearing


The first cause on the hot fast-paced hand grinding machine is the drag bearing. The Bearing is where the engine shaft is based. If a bearing is jammed, the shaft round of the grinding machine becomes heavy due to the friction between the bearings and the shaft. So long as the friction will become hot. This issue can be solved by replacing the jammed hand grinding machine bearing with the new bearing.

2. Loose Bearing


The loose Bearing will result in an unbalanced shaft rotation of the grinding machine. Such an imbalance will shake the shaft of the grinding machine at the time of spinning and will hold the other part. There will be friction that results in hot fast Nespresso. How to solve this problem is by replacing the koclak hand grinding bearings with the new bearings.

3. Stator Damaged


In the hand grinding machine there is a stator which is a pair of copper wire rolls that are silent or stationary and have two lines of electric current. If one of these lanes broke down/died, then the armature turnover became irregular. So that the armature will be able to hold stator and result in a hot fast machine or even a short circuit that resulted in the reel of the stator burned.

To find out the disconnect and absence of the voltage in the stator, we can use Multitester. And if you find the stator that is dead next, immediately to overcome it by rerolling the stator or by replacing it with a new one.

These are some of the causes and how to fix hot fast grinding machine. If experiencing the problem, immediately improve the hand grinding machine. Hopefully this article is helpful.

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2